HaTe® filter and woven grids are manufactured from mono- and multifilament yarns as well as flat or split tape.

The selection of synthetic raw material, tensile strength and mesh size is made to suit the application. We have been manufacturing and marketing HaTe® wovens and fine-mesh woven grids for over 30 years in many combinations of different raw materials and yarns. Some wovens are specially coated, where required for a particular use.

HaTe® woven filters ensure that water can flow continuously, without creating hydraulic pressures. The special stress and strain behaviour ensures that even under heavy load, the structure remains stable and the required filtration properties are retained.

HaTe® woven grids are placed on freshly seeded or planted earthwork slopes for early erosion protection. The openings in the specially developed woven grid readily accommodate the roots of newly planted vegetation.

HaTe® wovens are used to separate, filter, reinforce and contain.

Typical applications: ornamental lakes or leisure waterways/drainage trenches lower layer dewatering slope construction storage lagoons railways

Properties: stable pore sizes ensures pore size compatibility with adjacent soils flexibility robustness environmentally-friendly very low transport costs

Information about areas of application:

Earthworks and foundations

Roads

Railways

Airports

Hydraulic engineering

Landfill

Industrial and contaminated land reclamation and ground restoration

Reports:

HaTelit® asphalt reinforcement at London Luton Airport

321 KB

Press Release:

Innovative application - 'green' cellular bank protection ...

HaTe^® is a registered trademark of HUESKER Synthetic GmbH